About
Plugin
API
Terms of Service
Privacy
Contact
Upload
Sign in
Making spoked wheels
Share
u1147
1
view
Making spoked wheels
How I make spoked wheels.
31
images
Most recent
Most recent
Oldest
Most viewed
AZ
Embed codes
Sub albums
20230110-132527
20230110-132149
20230110-131620
20230110-130249
20230110-130956
20221203-133650
Some sanding and it's finished!
The wheel can be removed from the plan to install the last course.
The 3rd course goes on the top, but in the opposite direction as the 1st course.
The next course of spokes goes on the same way, but to the other end of the axle.
Apply CA glue to both ends of the spoke with a toothpick. The 1st course should look like tis.
The 1st course of spokes installed.
Use CA glue applied with a toothpick to both ends of the spoke.
Insert a spoke in every 4th hole so the end of the spokes are all in the same direction on the axle.
Ready for the spokes.
Marking and cutting the spokes from .019" wire. Be sure to sand the wire bright with emory cloth.
Measuring for the length of the spoke. 13.5 mm.
Tack down the wheel to the plan again.
1/16" O. D. axle held in place with a pin.
Drill holes with an 1/32" bit.
Glue 3 layers.
Cut the outsides.
Cut out the centers.
Making the wheels from 1/16" balsa. 3 pieces for each wheel.
20221201-162017
Load more
Load more
Load more
There's nothing to show here.
Embed codes
Viewer links
HTML full linked
HTML thumbnail linked
BBCode full linked
BBCode thumbnail linked
copy
copy
copy
copy
copy
Embed codes
Viewer links
HTML full linked
HTML thumbnail linked
BBCode full linked
BBCode thumbnail linked
copy
copy
copy
copy
copy
Share
__privacy_notes__
Link
copy
